Fighting Pronghorn Bowie (7 in.)
Product Description for Fighting Pronghorn Bowie (7 in.)
Maker: Ed Fowler, M.S. (click to see more by this maker)
Item num: 92317
*** This is handmade and one-of-a-kind ***
Blade length: 7.00 in.
Total length: 12.00 in.
Blade height (at heel): 1.25 in.
Blade thickness (near bolster): 0.21 in.
Item weight: 14.90 oz.
Shipment weight: 19.6 oz.
Blade: Hand forged 52100 carbon steel with a low temp triple quench and triple temper for high performance edge retention
Handle: Sheep horn
Sheath: 14 oz. waxed harness leather desk sheath
Description: Mastersmith Ed Fowler's knives are the hallmark of a perfected high performance knife. Ed's heat treat has proven to create some of the sharpest and most long lasting edges found anywhere. This Fighting Bowie has been in a private collection since it was made in 2007. It has been meticulously cared for and is in new condition.
The blade was forged at low temperature from 52100 carbon steel. This is a high carbon, high chrome steel in a very pure form and results in a knife steel that is as good as it gets. The steel was forged from a 5-1/2 inch round bar, resulting in a reduction ratio of over 95 points. It was subjected to over 50 low temperature thermal cycles, which requires a lot of hand hammer work. The numerous thermal cycles and high degree of reduction by forging has produced a blade that manifests fine grain and a microstructure known as banding, a property of steel that results in high tensile strength and low resistance to compression. The result is a blade that you can count on through tough use.
The blade was hardened three times in 24 hour intervals, then tempered three times -- again, in 24 hour intervals. These hardening and tempering methods were carefully developed for 52100 carbon steel, resulting in a blade that is easy to sharpen, yet holds an edge better than any I have tested.
The large sheep horn handle fits comfortably into the hand. The horn was harvested by Ed from a Rambouillet buck sheep, processed, and aged for 7 years to result in a very stable handle. When wet, sheep horn does not become slippery, and it is amazingly durable. The spacer is created by taking two sheep horn end cuts and aligning them outward, producing a very pleasing effect. The brass guard features Ed's Willow Bow engraving.
The knife is accompanied by a leather desk sheath, also created by Ed. Excellent fit and finish throughout.
Availability: Not currently available